A Vintage Classic Mid-1970's AM/FM Stereo Receiver
All pre-owned product is tested in our service department and have been passed for sale... and comes with a 90 day warranty!
In very nice condition! - especially for its age. Original box and packing are NOT available, but we will pack carefully! Full Specs are last image.
Pix showing the front "lit" are stock.
A CLASSIC and from their top of the line receivers - 1973-1977 and sounds great!
You enjoy greater stereo power and superior stereo performance at much less cost with Sansul's newest medium-priced FM/AM stereo receiver, the 771. Thanks to its refined CBM (Circuit Board Module) construction, the 771 outperforms many higher-priced receivers in the field. Here's how:
Thanks to CBM, which simplfies construction, reduces costs and increases electronic capabilities, the moderately-priced 771 is able to offer a very superior power amplifier-an all-stage direct-coupled OCL powerhouse delivering a continuous RMS 40W/40W (total music power of 140 watts) to drive up to two stereo pairs of speakers at a time with less than 0.5% total harmonic distortion and a surprisingly wide power bandwidth of 15 to 40.000Hz. Its FM/AM tuner features an MOS FET-equipped FM section with sensitivity of 2.0pV (IHF) to pull in the fuzziest of stereo signals with surprising clarity. And its preamplifier and control sections are equally outstanding, providing inputs and controls for two stereo tape tape decks, two AUX, a microphone circuit, a superior 2-stage direct-coupled phono equalizer, distortion-free tone controls with FETs. audio muting, low/high filters and loudness, and a unique stereo/mono switch which bypasses the FM multiplex circuit when it is turned to mono position.
Specs:
Tuning range: FM, MW
Power output: 32 watts per channel into 8Ω (stereo)
Frequency response: 15Hz to 30kHz
Total harmonic distortion: 0.5%
Damping factor: 60
Input sensitivity: 2.5mV (mic), 2.5mV (MM), 100mV (DIN), 100mV (line)
Signal to noise ratio: 70dB (MM), 80dB (line)
Channel separation: 45dB (MM), 45dB (line)
Output: 100mV (line), 30mV (DIN)
Speaker load impedance: 4Ω to 16Ω
Semiconductors: 3 x FET, 3 x IC, 49 x transistors, 25 x diodes, 4 x zener diodes
Dimensions: 480 x 135 x 300mm
Weight: 12kg
